b'SAFETY EN1SAFETY1 .1OverviewThese instructions for the installation, commissioning and maintenance of the burner are for use by technicians from professional heating companies that are qualified to carry out these activities. The instructions contain indications and information on how to move, handle, activate, adjust, maintain and remove the appliance and how to dispose of the components at the end of the their useful life.The instructions must be followed and all applicable legislation complied with in order to ensure safe working conditions.This manual should be stored near the product and made available to all operators involved in its use.1 .2Intended useThe burner is designed to act as a heat source for heating and DHW generation systems in which water is the heating fluid.Any other or wider application is outside of the specified intended use.To avoid risks, the burner should only be used: for its specifically intended use under the appropriate safety conditions following the instructions for installation, commissioning and maintenance in compliance with the max. and min. operating values in compliance with the required maintenance activities immediately repairing any malfunctions that could compromise safety maintaining all notes and notices applied to the product so that they remain legible over timethe burner cannot be installed outdoors, unless installed in a boiler specifically designed for that use. If installed outdoors, climatic conditions could cause direct damage to the burner due to the presence of water or frost or cause the components to overheat.5/64'